Construction of nose gear

Antworten
Marcel
Beiträge: 6
Registriert: Mo 11. Feb 2013, 16:32

Construction of nose gear

Beitrag von Marcel »

We had a collaps of our nose gear during landing (gear motor retracted from bearing like in an emergency gear down).
During the following high speed slide over the asphalt runway we lost the gear door and the strut was partially worn.
For repairs we need to know how many Kevlar layers and how many Carbon layers are used to make the nose gear strut. Does anyone have this knowledge?
dew
Administrator
Beiträge: 63
Registriert: Mi 3. Okt 2012, 10:11

Re: Construction of nose gear

Beitrag von dew »

Hello Marcel,

you can try to contact Steinbeis Flugzeug- und Leichtbau GmbH.

http://www.sfl-gmbh.de/impressum/

As far as I was told they still have all the plans for the speed canard and can also manufacture them.

Good Luck.

Claus
Riku
Beiträge: 3
Registriert: Mo 19. Feb 2018, 14:51

Re: Construction of nose gear

Beitrag von Riku »

Hello
Thats a good information! What resin you have planned to use at repair? Original resin is Rutapox but is there some approved alternative resin? We are planning to use Araldit LY5052, but we havent found any documentation that it is acceptable.

Br Riku
D-EJDB
Beiträge: 15
Registriert: Sa 3. Nov 2012, 00:18

Re: Construction of nose gear

Beitrag von D-EJDB »

in my opinion,
better is to contact:
info@LTB-Lindner.com
they do have plans and knowledge, let them do the work , it is not cheap but worth the money!
regards
Stefan
Antworten